Suunto Transmitter (for D4i)

Wrist, console...for recreational or technical diving. Questions and information.

Suunto Transmitter (for D4i)

Postby michaelgregg » Fri Dec 07, 2012 1:57 pm

Hi,

I'm upgrading my old Uwatec Aladin Z Nitrox Computer with a Sunnto D4i & Suunto transmitter and just want to double check that the old transmitter can be simply swapped out before I commit. Currently goes into a std ScubaPro first stage HP port. I'm buying from out of town so will have to fit it myself.

Anyone had any experience with these?

Cheer,
Michael
michaelgregg
Newbie
 
Posts: 1
Joined: Thu Dec 06, 2012 8:41 pm

Re: Suunto Transmitter (for D4i)

Postby ChuckyBob » Fri Dec 07, 2012 3:40 pm

Are you asking if the old transmitter can be un screwed form the 1st stage and the new transmitter be screwed back in?

Then the answer is yes ( 99%). There is only one thread type used in modern 1st stage regulators for HP ports and that is a 7/16th 20 tpi thread with an oring seal (SAE).

Just be care full to not over tighten it. It is sealed with the O ring and not the thread. General rule is finger tight seals it and another 1/4 turn or so if needed stops it working loose.
User avatar
ChuckyBob
Member
 
Posts: 1288
Joined: Fri Apr 03, 2009 1:51 pm
Location: over here.


Return to Dive Computers

Who is online

Users browsing this forum: No registered users and 1 guest

cron