Page 1 of 1

Suunto Transmitter (for D4i)

PostPosted: Fri Dec 07, 2012 1:57 pm
by michaelgregg
Hi,

I'm upgrading my old Uwatec Aladin Z Nitrox Computer with a Sunnto D4i & Suunto transmitter and just want to double check that the old transmitter can be simply swapped out before I commit. Currently goes into a std ScubaPro first stage HP port. I'm buying from out of town so will have to fit it myself.

Anyone had any experience with these?

Cheer,
Michael

Re: Suunto Transmitter (for D4i)

PostPosted: Fri Dec 07, 2012 3:40 pm
by ChuckyBob
Are you asking if the old transmitter can be un screwed form the 1st stage and the new transmitter be screwed back in?

Then the answer is yes ( 99%). There is only one thread type used in modern 1st stage regulators for HP ports and that is a 7/16th 20 tpi thread with an oring seal (SAE).

Just be care full to not over tighten it. It is sealed with the O ring and not the thread. General rule is finger tight seals it and another 1/4 turn or so if needed stops it working loose.